Cabletron Systems HSIM-W6 Installation Manual

Also see for CyberSWITCH HSIM-W6: Setup guide Configuration guide User guide User guide

Contents

Investigating Software Configuration ProblemsHSIM-W6 Installation Guide4-11Investigating Software Configuration ProblemsSoftware problems usually occur when your software configuration contains incomplete orincorrect information.Connection to Device Fails During Software Configuration• For a LAN connection, verify that the IP address matches the IP address previously stored intothe configuration of the router. You must have previously (through QuickSET) set the EthernetLAN IP address and Subnet Mask, enabled IP routing, saved the Ethernet configuration changesand rebooted the router for the new IP address to take effect.• Check that your LAN cable is wired correctly and each end securely plugged in.• Make sure that an IP route exists between your local PC and the HSIM-W6. The PC andHSIM-W6 must be on the same IP subnetwork or the HSIM-W6 must be reachable through arouter on your LAN.• Check Network TCP/IP properties under Windows 95 or Windows NT, as described in theRead Me First! document.User Cannot Communicate with Remote Network StationIf Bridging,• Check that the Bridging Default Destination is set.• Check that bridging to/from the remote router is set on.• Be sure to reboot if you have made any bridging destination or control changes.If TCP/IP Routing,• Check that TCP/IP Routing is set on and is enabled at the remote end.• Check that the IP address of the LAN beyond the remote router is correct, as well as theassociated Subnet Mask.• If the remote router WAN IP address and Subnet Mask are required, check that they have beenspecified correctly.• Check that, if required, the source and remote WAN IP addresses are on the subnetwork.• Check that you have seeded the routing table, if RIP is not allowed to flow on the WAN link.• Be sure to reboot if you have made any IP address, control or protocol option changes.