Cabletron Systems SmartSwitch 04-0053-01 User Manual

Also see for SmartSwitch 9A100: User guide Upgrade instructions Installation and setup guide

Contents

Cabletron Systems SmartSwitch 04-0053-01 User Manual Manual pdf 61 page image

SmartSwitch ATM User Guide 4-5Routing UNI Routes4.3 UNI ROUTESUse the add atmroute command to create UNI routes. For example, connect an end station adapter (with MAC address00:11:22:33:44:55) to port 7A2 of a SmartSwitch 6500. If the adapter does not support ILMI or its ILMI is incompatiblewith the SmartSwitch 6500, you must create a static UNI route between the adapter and port 7A2 of the SmartSwitch6500.The following example works with any ATM SmartSwitch, however, the port numbering may be different (for instanceA2 instead of 7A2):1. Enter the show netprefix command to obtain the netprefix of port 7A2:SmartSwitch # show netprefixPortNumber(ALL) : 7a2Port# NetPrefix============================================================================7A2 39:00:00:00:00:00:00:00:00:00:14:59:00SmartSwitch #2. Reconfigure the adapter with an ATM address made from the netprefix of port 7A2 and the adapter’sMAC address: 39:00:00:00:00:00:00:00:00:00:14:59:00:00:11:22:33:44:55:00.3. Use the add atmroute command to create a static UNI route that specifies port 7A2 and the adapter’snew ATM address.SmartSwitch # add atmroutePortNumber() : 7a2AtmAddress() : 39:00:00:00:00:00:00:00:00:00:14:59:00:00:11:22:33:44:55:00PrefixLength(152) :Index(0) :Type(Internal) : — Take the default to make this an “internal” routeScope(0) :MetricsTag(0) : — See Section 4.4 for information on metricsAdvertising(NO) :yes — Advertise this address into the PNNI domainSmartSwitch #Note Always set the Type parameter of the add atmroute command to internal (thedefault) for UNI routes. This indicates that the route is internal to the PNNIdomain.Note The add atmroute command allows you to specify a set of metrics to be used withthe route. Metrics are created using the add pnnimetric command, and areassigned to routes by metric tag numbers. By setting the appropriateadministrative weights within metrics, it’s possible to create parallel load-sharingor fail-over routes. For more information about metrics, administrative weights,and metric tags, see Section 4.4, Route Metrics.