SSR User Reference Manual 3NoticeNoticeCabletron Systems reserves the right to make changes in specifications and other information contained in thisdocument without prior notice. The reader should in all cases consult Cabletron Systems to determine whetherany such changes have been made.The hardware, firmware, or software described in this manual is subject to change without notice.IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR ANY INCIDENTAL, INDIRECT,SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED TOLOST PROFITS) ARISING OUT OF OR RELATED TO THIS MANUAL OR THE INFORMATIONCONTAINED IN IT, EVEN IF CABLETRON SYSTEMS HAS BEEN ADVISED OF, KNOWN, OR SHOULDHAVE KNOWN, THE POSSIBILITY OF SUCH DAMAGES.© Copyright November 1998 by:Cabletron Systems, Inc.35 Industrial WayRochester, NH 03867-5005All Rights ReservedPrinted in the United States of AmericaOrder Number: 9032578-02LANVIEW is a registered trademark, and SmartSwitch is a trademark ofCabletron Systems, Inc.CompuServe is a registered trademark of CompuServe, Inc.i960 microprocessor is a registered trademark of Intel Corp.Ethernet is a trademark of Xerox Corporation.FCC NoticeThis device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) thisdevice may not cause harmful interference, and (2) this device must accept any interference received, includinginterference that may cause undesired operation.NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmfulinterference when the equipment is operated in a commercial environment. This equipment uses, generates, andcan radiate radio frequency energy and if not installed in accordance with the operator’s manual, may causeharmful interference to radio communications. Operation of this equipment in a residential area is likely to causeinterference in which case the user will be required to correct the interference at his own expense.WARNING: Changes or modifications made to this device which are not expressly approved by the partyresponsible for compliance could void the user’s authority to operate the equipment.
