Setting the ClockThe navigation system time and the analog clockoperate independently. Changing the time through thenavigation system does not change the time on theanalog clock. See Analog Clock on page 3-22 to changethe analog clock time.To set the time for the navigation system:1. Press the CONFIG key to enter the configure menuoptions, then press the CONFIG key repeatedlyuntil the time is selected or touch the time screenbutton.2. Press the Hours and Minutes − (minus) and+ (plus) signs to decrease or to increase the time.See “Setting the Clock” under Configure Menuon page 4-40 for more information.Entering an Address and Point ofInterest, and Storing PresetDestinationsEntering an AddressEnter a destination by inputting the city name first:1. If the radio is already on with a map disc inserted,skip to Step 5.2. Press O to turn the system on.3. Insert the DVD map disc. See “Installing the MapDVD” under Maps on page 4-14 for moreinformation.4. A caution may appear. Touch the OK screen buttonto proceed.5. Press the DEST hard key.6. Press the 2 Address Entry screen button.7. Select the state/province screen button, if needed,to change the current state or province. A list of allof the available states and provinces appear.Select the state or province.8. Once a state or province has been selectedthe City name category is automatically selectedfor entry.If five or less names are available, a list displays. Ifmore than five are available, the List screenbutton displays a number. This number representsthe number of available cities. Select this buttonto view the list and select a city.9. Once a city has been selected the Street namecategory is automatically selected for entry.If five or less streets are available for the selectedcity, the system displays the list of streets. If morethan five streets are available the system displays thealpha keyboard. Start entering the street name. Iffive or less names are available, a list displays. Ifmore than five are available, the List screen button4-8
