Black plate (51,1)Cadillac SRX Owner Manual - 2011Instruments and Controls 5-51Gate Operator and CanadianProgrammingIf you have questions or need helpprogramming the Universal Remotesystem, call 1‐800‐355‐3515 or goto www.homelink.com.Canadian radio-frequency lawsrequire transmitter signals to timeout or quit after several seconds oftransmission. This may not be longenough for the Universal Remotesystem to pick up the signal duringprogramming. Similarly, some U.S.gate operators are manufactured totime out in the same manner.If you live in Canada, or you arehaving difficulty programminga gate operator or garage dooropener by using the “Programmingthe Universal Remote System”procedures, regardless of whereyou live, replace Step 2 under“Programming the UniversalRemote System” with the following:Continue to press and holdthe Universal Remote systembutton while you press andrelease every two seconds (cycle)the hand-held transmitter buttonuntil the frequency signal hasbeen successfully accepted bythe Universal Remote system.The Universal Remote systemindicator light will flash slowly atfirst and then rapidly. Proceed withStep 3 under “Programming theUniversal Remote System” tocomplete.Universal Remote SystemOperationUsing the Universal RemoteSystemPress and hold the appropriateUniversal Remote system buttonfor at least half of a second.The indicator light will come onwhile the signal is being transmitted.Erasing Universal RemoteSystem ButtonsAll programmed buttons should beerased when the vehicle is sold orthe lease ends.To erase all programmed buttonson the Universal Remote systemdevice:1. Press and hold down thetwo outside buttons until theindicator light begins to flash.This should take about10 seconds.2. Release both buttons.Ofrecido por www.electromanuales.com
