Cargo Cover{CAUTION:An improperly stored cargo cover could bethrown about the vehicle during a collision orsudden maneuver. You or others could beinjured. If you remove the cover, always storeit in the proper storage location. When you putit back, always be sure that it is securelyreattached.If you have a cargo cover, you can use it to cover itemsin the cargo area of your vehicle.To use the cover, do the following:1. Pull the cover handle toward the rear of the vehicle.2. Latch the cover posts into the retaining socketson the cargo area trim panels.To return the cover to the retracted position, do thefollowing:1. Pull up on the cover handle to release the coverposts from the retaining sockets.2. Let the cover move forward to the full retractedposition.To remove the cover from the vehicle, do the following:1. Let the cover go all the way into the holder.2. Then, grasping the passenger’s side cover endcap,push the cover endcap toward the driver’s side ofthe vehicle. The endcap should lock in thecompressed position.3. Lift the cover up on the passenger’s side, swing thecover rearward and take it out of the vehicle.To put the cover in the vehicle, do the following:1. Make sure the cover slot in the holder facesrearward with the round surface facing down.2. Then, hold the cover at an angle and place thecover holder tab into the slot in the driver’s sidetrim panel.3. Move the other end of the cover forward and hold itnext to the passenger’s side trim panel slot.4. Push the button on top of the passenger’s sideendcap. This will allow the cover to extend intothe trim slot.5. Lightly pull on the cover holder to make sure it issecure. On some models there are two slots. Theslots furthest forward allow the cover to be usedif the third seat is removed or folded down.2-45
