CalAmp Fusion LTE User Manual

CalAmp Fusion LTE User Manual Manual pdf 16 page image

16Normal power-up sequenceThe LEDs will act differently during boot up than during normal operation.Step Action LED activity1 Apply power to the unit. NA2 Internal 5-volts power supply turns-on PWR = RED during approx 1 second3 Internal 1.8-volt and 3.3-volts power supply turn-on Every INDICATOR (except those attached to Ethernet)become AMBER during approx 400 ms4 Hardware initialization completedEvery INDICATOR become OFF except PWR which remainAMBER.5 Bootstrap program runsPWR blinks AMBER.6 Application startsPWR becomes solid GREEN.7 Application runs normallyPWR is solid GREEN. STAT is solid GREEN1.8 ANTENNALTE antenna connections are SMA female connectors and must be used with antenna with SMA male connectors. Whenusing a direct mount or rubber duck antenna, choose the antenna specific to your band requirements. Mounting optionsand cable lengths are user’s choice and application specific. Each WWAN interface supports a primary and diversity antennaconnector.Connect an active 3-5.5V GPS antenna, with an average gain >-5dBi, if using the GPS functionality.Fusion is available with WiFi options, using RP-SMA connectors. Depending on the model, connect each WiFi antenna to theproper connector. If equipped with a simple non-MIMO WiFi option, connect the primary WiFi antenna to the connectorlabeled “M’. For Fusions equipped with MIMO WiFi (2x2 or 3x3 MIMO), connect the WiFi antennas to any free RP-SMAconnector.This device is factory configured with default settings and is ready to be customized via HTML.