172 GETTING STARTED2.1 PACKAGE CONTENTS Fusion LTE Modem Power Cable Mounting Bracket and hardware (Fixed or Mobile depending on device purchased) Quick Start Guide2.2 POWER SUPPLY CONNECTIONThe fusion is shipped with a DC power cable used to connect the device to a DC source. The cable includes a fuse holder.Insert the fuse in the power cable fuse holder prior to powering on the unit. The cable connections are listed below.Pin Wire Color Description Notes1 Red V IN DC input power lead, 13.8V nominal (10V to 30V range)2 Black Ground Connect to power supply ground3 White Ignition Sense Standard ignition-on signal. Maximum voltage above which Ignition_sensewill be detected as ignition asserted = 9.0V;If IGN Sense not used, this line must be connected to VIN4 Yellow External Alarm Input External alarm input, (active low) can be left floating if not used2.3 DEVICE CONNECTIONS1. Insert the SIM/UICC card into the SIM/SVC slot as shown. If your solution requires only one cellular module, insertthe SIM into the slot corresponding to the populated module (WWAN0 (left), WWAN1 (right). If you are using adual card solution, you will need a SIM card in each slot.2. Connect the antennas to the appropriate connectors on the front panel of the Fusion LTE modem.3. Connect an Ethernet cable into the Eth1 port and plug the other end into the network port of your PC.4. Connect the Power Cable to the modem PWR port and connect to an acceptable DC power source (10-30VDC).

Product Overview

Features and Benefits

Order Informaiton

External Connectors

leds

Antenna

Getting Started

LAN Configuration

LTE COnnection

Web Interface

General Settings

Remote Administration

ETHERNET 0 / 1 /

IP Settings

Statistics

Wifi (Access Point)

Wireless settings

status

siTe survey

Carrier Settings

Configuration

interface priority

port forwarding

MAC Filtering

IP Filtering

Static Routes

Security

Monitor & Control

SNMP

NMEA

Power Management

Monitoring

I/O Control

AAVL Settings

Maintenance

Firmware

Hardware

Service and Support

Appendix A – Abbreviations

Appendix B – Warranty Statement

CalAmp Fusion LTE User Manual

Fusion LTE