RCD 235BTi • ManualREDIALThe unit stores the all the incoming call numbers automatically. To access the call list, proceed as follows: Short pressBT key to go into BT menu and rotate the VOL knob to show the sequence in below: CALL LIST --> L-DAI.When CALLLIST is shown on the display, press BT key to go to BT menu. Rotate VOL knob to choose phone number(only stores incoming calls) and then press button on the panel to dial out the number.When L-DIAL is shown on the display, press press button on the panel to call the last number. The LCD displays “DI-ALING” and phone displays the phone number and name if the number stored to phone book.INCOMING CALLS *When there is an incoming call the LCD display will show the phone number and name if the number is stored in thephone book.CALLER ID NOTES *The incoming caller ID name or number is not guaranteed to display on this device as this function varies betweendifferent phone manufacturers, models and service providersMUSIC PLAYBACK VIA A2DPThis involves a cross-manufacturer Bluetooth profile. Stereo-audio signals are transmitted wirelessly via streamingbetween the playback unit (source) and receiver unit. To control the source remotely, the playback unit must supportthe AVRCP profile (Audio Video Remote Control Profile).Full functionality cannot be guaranteed due to the different unit manufacturers, models and software versions.• After you have connected the units to each other, start playing the music in your mobile phone.• Use the 7 or 8 button to select the next or previous track.HANDLING DISCS- Dirty, scratched or warped discs may cause skip ping or noise.- Handle the disc only by the edges. Do not touch its surface tokeep it clean.- Discs should be stored in their cases after use to avoid scratches.- Do not expose discs to direct sunlight, high humidity, high temperature or dust.- Prolonged exposure to extreme temperature can wrap the disc (such as leaving the discs in your car during summertime).- Do not stick or write anything on either side of disc. Sharp writing instruments, or the ink used in some felt-tip pens,may damage its surface.- Do not touch the unlabeled side. Do not attach any seal, label or data protection sheet to either side of a disc.CLEANINGCleaning discsFingerprints should be carefully wiped from the surface of disc with a soft cloth. Unlike conventional records, compactdiscs have no grooves to collect dust and macroscopic dirt, so gently wiping them with a soft cloth should removemost dust or stains. Wipe in a straight motion from the center to the edge.Caution: Never use a thinner benzine, record cleaner or anti staticspray on a compact disc. Such chemicals can damage its plasticsurface.