RCD 235BTi • ManualINSTALLING THE UNIT INTO THE ISO DASHBOARD SLOTNotes:• Choose a mounting location where the unit will not interfere with the normal driving function of the driver.• Before finally installing the unit, connect the wiring temporarily and make sure it is connected properly and theunit and system are working properly.• Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts cancause malfunctions.• Consult with your nearest dealer if installation requires the drilling of holes or other modifications ofthe vehicle.• Install the unit where it does not get in the driver’s way and cannot injure the passenger if there is a suddenstop, like an emergency stop.• If installation angle exceeds 30° from horizontal, the unit might not give its optimum performance. 30• Avoid installing the unit where it would be subject to high temperature, such as from direct sunlight, or hot air,from the heater, or where it would be subject to dust, dirt or excessive vibration.DIN FRONT/REAR-MOUNTThis unit can be installed either from “Front” (conventional DIN Front-mount) or “Rear” (DIN Rear-mount installation,utilizing threaded screw holes at the sides of the unit chassis). For details, refer to the following illustrated installationmethods.TAKE OUT TRANSIT SCRES BEFORE INSTALLATIONBefore installing the unit, please remove the two transit screws.