6.7.4.2 Internal installation of the radioNOTE:If the ET107 was ordered with a radio kit, skip this section and go directly to Externalinstallation of the radio (p. 45).The following components are provided in the radio kit for installation inside the ET107enclosure:(1) spread spectrum radio(1) internal antenna cable(1) enclosure mounting bracketThe radio comes mounted to the enclosure bracket. Install the assembly as follows.NOTE:Power the station down by moving the PS150 power switch to the Off position beforeinstalling any communication option. Remember to move the switch back to the On positionafter installing the enclosure.1. Mount the bracket and radio inside the enclosure using the three existing screws (FIGURE6-26 (p. 44)).2. Thread the smaller SMA connector end of the internal antenna cable underneath thebattery cables and screw it to the RF antenna connector on the radio.3. Attach the other end of the cable to the BNC RF bulkhead connector in the lower rightcorner of the enclosure. Make sure all connections are tight (FIGURE 6-26 (p. 44)).FIGURE 6-26. Radio mounted in the ET107 (battery not shown)Section 6. Installation 44
