Campbell MetData 1 Instruction Manual

Contents

Campbell MetData 1 Instruction Manual Manual pdf 30 page image

SECTION 3. INSTRUMENTATION INSTALLATION3-10bulkhead connector into the “punch-out”hole, located as shown in Figure 3.3-5.Install the bulkhead connector so that thecable is inside the MetData1. Connect theother end of the cable to the radio’s BNCconnector.6. Mount the antenna to the mast according tothe manufacturer's instructions. Connectthe antenna cable to the antenna and routethe cable. Connect the antenna cable tothe outside end of the coaxial bulkheadconnector as shown in Figure 3.3-5. Wrapthe connection with the self-vulcanizingrubber provided.CAMPBELLSCIENTIFICINC.MD9MULTIDROP INTERFACEMADE IN USASERIAL I/OTRANSCEIVERCARRIER DETECTFCC ID: ATH90F0233420050E.F.JOHNSON CO. U.S.A.DL 3420E.F. JOHNSON CANADA INC.mfg by E.F. JOHNSON USADOC T.A. 89178Serial No3400T144A 17858FIGURE 3.3-5. RF95 RF Modem andRF100/RF200 TransceiverTABLE 3.3-1. Station ID Numbers andCorresponding Switch Settings**Station Switch SettingsID 1234 567890 0000 0000X1 1000 0000X2 0100 0000X3 1100 0000X4 0010 0000X5 1010 0000X6 0110 0000X7 1110 0000X8 0001 0000X9 1001 0000X10 0101 0000X11 1101 0000X12 0011 0000X*255 1111 1111X* Station ID 255 is reserved for phone-to-RFbase stations.** See Appendix A in the RadiotelemetryNetwork Applications Manual for a table ofswitch settings.3.3.5.2 RF232 RF Base Station1. Install the base station antenna accordingto the manufacturer's instructions. Connectthe antenna cable to the antenna and routethe cable to the RF232.2. With the power cord disconnected, remove thefour screws that attach the RF232 lid. Removethe lid, and install the RF200 transceiver asshown in Figure 3.3-6. Connect the red wire tothe "12 V" terminal, and the black wire to the" " terminal inside the RF232. Connect themulti-colored ribbon cable to the RF modem;make sure that the keyway is properly aligned.3. Connect the antenna cable to the antennaconnector on the RF200. Reassemble theRF232 lid using the screws previouslyremoved.RadioTransceiverSC12 CableCoaxial Bulkhead Connector (wrapwith supplied self-vulcanizing rubber)Cable toAntenna