Cannon PROFESSIONAL 1000 Use And Installation Instructions

Also see for Professional 1000: Use and Installation Instructions Use and Installation Instructions Use and Installation Instructions Use and Installation Instructions Instruction manual

Contents

32ELECTRICAL CONNECTIONWARNING - THIS APPLIANCE MUST BE EARTHED. CONNECT TO A 230-240V A.C. SUPPLYONLY.Connection to the electricity supply should be made via a properly earthed, readily accessible wall socketwhich is adjacent to but not directly above, and not more than 1.25m away from the appliance and capable ofelectrical isolation.The mains lead should be routed such that it cannot touch hot parts of the cooker i.e. the back panel above aheight of 650mm from the floor.Should this plug not fit the socket outlet in your home it should be cut off and replaced with a suitable plug asoutlined below.NOTE: The removed plug cannot be used for any other appliance and should therefore be properly disposed ofand not left where children might find it and plug it into a supply socket - with the obvious consequent danger.I2 THE 2ITTED PLUG IS REMOVEDThe flexible mains lead must be correctly connected as below to a three pin plug of not less than 13 ampcapacity. If a B.S. 1363 fused plug is used, it must be fitted with a fuse which is approved to B.S. 1362.IMPORTANT: The wires in the mains lead fitted to thisappliance are coloured in accordance with the followingcode:GREEN AND YELLOW - EARTHBLUE - NEUTRALBROWN - LIVEThe power supply cable must be type H05RR-6As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markingsidentifying the terminals in your plug, proceed as follows:The wire which is coloured green and yellow must be connected to the terminal in the plug which is marked withthe letter E or by the earth symbol or coloured green or green and yellow.The wire which is coloured blue must be connected to the terminal which is marked with the N or coloured black.The wire which is coloured brown must be connected to the terminal which is marked with the letter L orcoloured red.When wiring the plug, ensure that all strands of wire are securely retained in each terminal. Do not forget totighten the mains lead clamp on the plug.As the appliance must be earthed, do not use 2-pin sockets outlets, if you are in doubt, consult a qualifiedelectrician.Should the mains lead ever require replacement, it is essential that this operation be carried out by a qualifiedelectrician and should only be replaced with a flexible cord of the same size i.e. 1.0mm2 cross sectional areaPVC cable, available from our parts department (see Back Cover).I2 A MOULDED PLUG IS 2ITTEDIn the event of replacing a fuse in the plug supplied an ASTA approved fuse to BS1362 must be fitted.NOTE: The fuse cover must be refitted when changing the fuse. In the event of losing the fuse cover the plugmust not be used until a replacement fuse cover has been obtained and fitted. A new fuse cover can beobtained from your local Electricity Board. The colour of the correct replacement fuse cover is that of thecoloured marks or inserts in the base of the plug.Make sure that the cable does not become trapped when pushing the cooker into position.Green &Yellow toEarthBrownto LiveBlue toNeutralCordClamp3 AmpFuseAll manuals and user guides at all-guides.com