104 PhotosAdditional FunctionsTaking Photos in y Manual Mode1 Set the mode switch to y.2 Turn on the camcorder.• By default, photos are recorded inthe built-in memory (c only)or on memory card X (d).You can select the memory that willbe used to record photos (0 35).• Please read the IMPORTANTsection before using an Eye-Ficard.3 Touch [3] to switch tomode.4 Press j halfway.Once the focus is automatically adjusted, h will turn green and one ormore AF frames will appear.5 Press j fully.The ACCESS indicator will flash as the photo is being recorded.IMPORTANT• Observe the following precautions while the ACCESS indicator is on orflashing. Failing to do so may result in permanent data loss.- Do not open the double memory card slot cover.- Do not disconnect the power source or turn off the camcorder.- Do not change the camcorder’s operating mode.• When recording photos on an Eye-Fi card in memory card slot Y, pho-tos will be uploaded automatically if you are within the range of a config-ured network. Always verify that Eye-Fi cards have been approved inthe country/region of use. See also Using an Eye-Fi card (0 146).Operating modes:
