Canon BJC-55 Service Manual

If you get a rewrite error, reset the following:Follow these procedures when an error occurs:DATA error:Occurs after each rewrite data has been transfered. Hence, data prior to the error isalready rewritten.Make sure that the floppy disk corresponds to the printer model. For example, donot rewrite data for BJC-50 with BJC-50v's. To transfer the correct data, check theconnection with the computer and re-enter the rewrite mode and repeat the steps.FLASH error:Occurs after each rewrite data has been transferred. Hence, data prior to the erroris already rewritten.Re-enter the rewrite mode and transfer the connect data. If the same error recurs,the flash ROM might be damaged. In that case, exchange the control board.RAM error:Occurs when the printer goes to check for available RAM to operate rewrite. Norewrite has taken place at this point. In this case, exchange the control board.3-27BJC-50Part 3: Operating InstructionsError messageDATA errorFLASH errorRAM errorPOWER indicatorLightsBlinksBlinksERROR indicatorBlinksBlinks (alternates withPOWER indicator)Blinks (simultaneous withPOWER indicator)Beepers2 long beepers2 long beepers2 long beepers