Software Setup 83Chapter 3Feeding OptionHere you can select the feeding method for document scanning.[Standard Feeding]This feeding method is good for scanning small batches of documents that areloaded one batch at a time: scanning stops when the loaded documents havebeen scanned.[Panel Feeding]This feeding method is good for scanning batches of documents of differentsizes: after loading the documents, press the Job button (assigned as a Startbutton on the scanner) to start scanning, and press the assigned Stop button tostop scanning.☞ When scanning documents with different-size pages, after loading thedocuments, you can adjust the document guide position.[Automatic Feeding]This feeding method is good for scanning batches of same-size documents:scanning starts when the scanner detects loaded documents, and stops whenyou press the Stop button.☞ When [Automatic Feeding] is selected, the [Setting] button is enabled toallow setting the delay time from when a loaded document is detected untilscanning starts. (See “Scanning Multiple Documents,” on p. 94.)☞ When the feed selection lever on the scanner is in the down position ( ),the feeding option is set to bypass mode and cannot be changed. (See “Howto Feed with the Bypass Mode,” on p. 30.)Batch Separation (ISIS driver only)Items available for selection depend on the Feeding Option setting: selectbatch separation timing (for when to start scanning) according to the batchseparation capabilities provided by the application program.With the [Standard Feeding] Feeding Option
