39An Error Message is Displayed While Using the Photo ViewerIf one of the following messages appears while using the Photo Viewer, printing may be disabled or thePhoto Viewer may be terminated forcibly.Error Massage Try ThisExecuting maintenance. Printing cannot be done in the maintenance mode.After completion of maintenance, pressing the Maintenance buttonallows you to exit the maintenance mode.Insert a memory card. Insert a memory card after checking its orientation.See “Using a Memory Card” on page 6.If a memory card has already been inserted, remove it and then insertit again. Next, check that the Indicator lamp stays on.The printer’s card slot hasbeen write-enabled. ......The memory card utility started on the computer has write-enabled thecard slot. When the card slot is write-enabled, the printer cannot printimages.When you have finished writing data to the card, cancel the write-enable mode. For the cancellation procedure, see “Setting up the CardSlot as the Memory Card Drive of the Computer” on page 20.There is a problem with thememory card or it is notinserted. ......z The memory card is inserted incorrectly.Insert the memory card after checking its orientation. See “Using aMemory Card” on page 6.If a memory card has already been inserted, remove it and theninsert it again. Next, check that the Indicator lamp stays on.z The memory card cannot be read.Image data edited/processed on the computer must also be printedfrom the computer.Insufficient disk space. ...... The hard disk of the computer does not have a sufficient free space.Delete unnecessary files on the hard disk to create a sufficient freespace, then start the Photo Viewer again.Insufficient memory. ...... The computer does not have sufficient free memory. Close someapplications or increase virtual memory, then start the Photo Vieweragain.A digital camera isconnected to the printer.......Printing from a computer or the operation panel cannot be done whena digital camera or digital video camcorder is connected to the printer.After completion of operation from the digital camera, disconnect theconnection cable.Failed to communicatewith the printer. ......The computer cannot communicate with the printer.Check whether the cable is connected securely between the printerand computer.Turn the printer off and on again, then start the Photo Viewer again.Failed to print. ...... An unexpected error occurred during printing.Turn the printer off and on again.An internal error (code =nnnn) occurred. ......(n: Alphanumericcharacter)An internal error occurred.Turn the printer off and on again, then start the Photo Viewer again.If the same error persists, reboot the computer and then start the PhotoViewer again.