Canon ImagePress C800 Quick Start Manual

7Important Safety InstructionsIMPORTANTDo not install the machine in the following locations• A location subject to rapid changes in temperatureand humidity• A location near equipment that generates magneticwaves or electromagnetic waves• A location where chemical reactions occur, such as alaboratory• A location exposed to corrosive gas or toxic gas• A location where the floor may be warped due tothe weight of the machine, such as on a carpetAvoid poorly ventilated locationsThis machine generates a slight amount of ozoneetc. during normal use. Although sensitivity to ozoneetc. may vary, this amount is not harmful. Ozone etc.may be more noticeable during extended use or longproduction runs, especially in poorly ventilated rooms.It is recommended that the room be appropriatelyventilated, sufficient to maintain a comfortableworking environment, in areas of machine operation.In addition, do not install this machine where itexhausts directly onto a person.Do not install the machine in a location wherecondensation occursIf the room where the machine is installed is heatedrapidly, or the machine is moved from a cool, drylocation to a hot, humid location, water droplets(condensation) may form inside the machine. Thismay result in paper jams, poor print quality, or amalfunction. To prevent these problems, wait atleast two hours before using the machine in order toadapt the machine to the ambient temperature andhumidity.Provide Adequate Installation SpaceProvide enough space on each side of the machine for unrestricted operation.76 7/8" (1,952 mm)60" (1,524 mm)4" (100 mm) or more*1289 3/8" (7,349 mm)31 1/2" (800 mm) or more*269 1/2" (1,765 mm)When the Output Tray-A1, Duplex ColorImage Reader Unit-H1, and UprightControl Panel-D1 are attached.When the Two-Knife Booklet Trimmer-A1, Booklet Trimmer-D1, SaddleFinisher-AM2, Paper Folding Unit-F1, High Capacity Stacker-G1, PerfectBinder-D1, Professional Puncher Integration Unit-C1, ProfessionalPuncher-B1, Document Insertion Unit-M1, Duplex Color Image ReaderUnit-H1, Upright Control Panel-D1, and Multi-drawer Paper Deck-B1 areattached.*1 Make sure to provide at least 31 1/2" (800 mm) of space if you attach one or more of the following: Paper Folding Unit-F1, ProfessionalPuncher-B1, Document Insertion Unit-M1, Multi-drawer Paper Deck-B1, Perfect Binder-D1, or High Capacity Stacker-G1.*2 Make sure to provide at least 4" (100 mm) of space if none of the Paper Folding Unit-F1, Professional Puncher-B1, Document InsertionUnit-M1, Multi-drawer Paper Deck-B1, Perfect Binder-D1, or High Capacity Stacker-G1 is attached.