Canon MAXIFY iB4060 Online Manual

Also see for MAXIFY iB4040: Manual Manual

Regulatory and Safety InformationFor models containing lithium battery• Dispose of used batteries according to the local regulations.• Risk of explosion if battery is replaced by an incorrect type.Users in the U.S.A.FCC Notice (U.S.A. Only)For 120V, 60Hz modelModel Number: K10409 (Contains FCC ID: AZDK30357)This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interferencereceived, including interference that may cause undesired operation.Note: This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipment generates, uses and can radiate radiofrequency energy and, if not installed and used in accordance with the instructions, may cause harmfulinterference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. If this equipmentdoes cause harmful interference to radio or television reception, which can be determined by turning theequipment off and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver isconnected.• Consult the dealer or an experienced radio/TV technician for help.Use of a shielded cable is required to comply with Class B limits in Subpart B of Part 15 of the FCC Rules.Do not make any changes or modifications to the equipment unless otherwise specified in the manual. Ifsuch changes or modifications should be made, you could be required to stop operation of the equipment.FCC ID:AZDK30357Changes or modifications not expressly approved by the party responsible for compliance could void theuser's authority to operate equipment.This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.The equipment complies with FCC radiation exposure limits for at uncontrolled equipment. Thisequipment should be installed and operated with minimum distance at least 20cm between the radiatorand persons body (excluding extremities: hands, wrists, feet and ankles) and must not be colocated oroperated with any other antenna or transmitter.Canon U.S.A., Inc.One Canon ParkMelville, New York 117471-800-652-2666107