4. Specify the side to be stapledThe best Stapling Side is selected automatically from the Orientation and Page Layout settings. Tochange the setting, select another stapling side from the list.5. Set the margin widthIf necessary, click Specify Margin... and set the margin width, and then click OK.6. Complete the setupClick OK on the Page Setup tab.When you execute print, the document is first printed on one side of a sheet of paper. After one side isprinted, reload the paper correctly according to the message.Then click Start Printing to print the opposite side.ImportantWhen a media type other than Plain Paper, Hagaki A, or Hagaki is selected from the Media Typelist on the Main tab, Duplex Printing appears grayed out and is unavailable.When Borderless, Tiling/Poster or Booklet is selected from the Page Layout list, Duplex Printingand Stapling Side appear grayed out and are unavailable.Duplex Printing can be performed only when one of the following paper sizes is selected from PageSize on the Page Setup tab.Letter 8.5"x11" 22x28cm, A5, A4, B5, Hagaki 100x148mmAfter printing the front page, there is an ink drying wait time before starting to print the back page(Operation stops temporarily). Do not touch the paper during this time. You can change the ink dryingwait time at Custom Settings on the Maintenance tab.When you use the automatic duplex printing function to print a postcard, print the address side firstand then print the message side.NoteIf the back side of the paper becomes smudged during duplex printing, perform Bottom PlateCleaning in the Maintenance tab.Related TopicsCleaning Inside the MachineChanging the Machine Operation Mode
