139Trouble?EMemory Card OperationPrintingEditingThe tape stops duringplayback pause.When playback pause continues for more than 4 minutes 30seconds during playback or audio dubbing, the camcordershuts off to protect tape and video heads. Playback the tapeagain and press the / pause button.–Problem SolutionMemory card cannot beinserted.Memory card was not facing the correct direction. Turn thememory card over and reinsert it.22Memory card cannot berecorded.Insert a memory card. 22Memory card is full. Replace the memory card or eraseimages.104Memory card is not formatted. Format the memory card. 105File number reached maximum value. Set [FILE NOS.] to[RESET] and insert a new memory card.73SD Memory Card is protected. Change the position of theprotect switch.22Memory card cannot beplayed back.Set the camcorder to CARD PLAY mode. 41Insert a memory card. 22Image cannot be erased. Image is protected. Cancel the protection. 103SD memory card is protected. Change the position of theprotect switch.22“ ” flashes red. Card error occurred. Turn off the camcorder. Remove andreinsert the memory card. Format the memory card if flashingpersists.105Problem SolutionThe printer is not operatingeven though camcorder andprinter are correctlyconnected.1. Set the camcorder to CARD PLAY mode.2. Disconnect and reconnect the USB cable.3. Turn off the printer and turn it back on.–Problem SolutionDubbing via the camcorder’sDV terminal does not work.Set [AV DV/ ] (OPTURA60) or [AV DV] (OPTURA50) to[OFF].73Wrong signal format. Dubbing may work via the AV terminal.Refer also to the instruction manual of the connected device.–Problem Solution
