Canon Optura Pi Instruction Manual

Also see for Optura Pi: User guide Software starter guide Instruction manual Install guide Brochure

Contents

Canon Optura Pi Instruction Manual Manual pdf 87 page image

Editing88E Side with arrowSide with arrowREW PLAY FFRECPAUSE SEARCHSELECTZERO SETMEMORYAUDIODUB. STOPA/VINSERT PAUSE SLOW+ /– /×2REW PLAY/PAUSE FF STOP REC PAUSE(LINE IN)Digital video equipment fitted with this terminal lets you edit, copy and transferdata digitally, with virtually no generation loss in image and sound quality. TheDV terminal is for both line-in and line-out, since a single DV cable can handledata in both directions.• If another Canon digital video camcorder is connected, the Dubbing Functioncan be used for digital-to-digital dubbing (i.e. with virtually no generation lossin image quality).• If a VCR is connected and an anomalous signal is sent from the VCR, theimages recorded on the tape may also be anomalous (although it may not appearso on the TV image), or not recorded at all.• You are unable to dub tapes recorded with the copyright protective signal.Dubbing to the camera:Operate from the controls on the LCD panel or the wireless controller.1. Use a Canon CV-150F DV cable (optional) to connect two digitaldevices together. Load a blank tape into the camera and a recordedtape into the other digital device.• Connect the DV cable with the sides of the plugs marked with the arrowsfacing as shown above.• Make sure the REC/SAVE tab on the blank tape has been slid to REC(closed position).2. Turn the POWER switch to VCR.3. Press the camera’s REC PAUSE button and start playback on theother digital device.• The camera enters record pause mode.• DV IN appears in the display when the playback device starts playback.4. To start/pause dubbing, press the PAUSE button.• You can monitor the image in the display as you dub.• Press STOP to finish dubbing.DV terminal/connectionsDubbing with Digital Video Equipment#4_OPTURA Pi_E(79-99) 1/25/00 13:42 Page 88 (1,1)