RecordingBasic Functions373 Move the / switch to the(Still images) position.4 If necessary, change the media forrecording the still images.Refer to Selecting the Media for theStill Images ( 37).5 Press halfway.• Once the focus is automaticallyadjusted, will turn green and one ormore AF frames will appear.• When you presson the wireless controller, thestill image is recorded immediately.6 Press fully.The CARD access or DISC accessindicator will flash as the still image isbeing recorded.IMPORTANTAvoid the following actions while the disc/cardaccess display ( or ) appears onscreen, and when either the DISC access orCARD access indicator is on or flashing. Failingto do so may result in permanent data loss.- Do not subject the camcorder to vibrations orstrong impacts.- Do not open the disc cover or the memorycard slot cover and do not remove the disc ormemory card.- Do not disconnect the power source or turn offthe camcorder.- Do not change the position of the /switch or the operating mode.NOTESIf the subject is not suitable for autofocus,turns yellow. Adjust the focus manually( 56).When the subject is too bright,“OVEREXP.” starts flashing. In such case, usethe optional FS-H37U ND filter.Selecting the Media for the PhotosYou can record still images on thememory card or the disc. The defaultmedia for still images is the memory card.As long as you do not change therecording destination, still images will berecorded on the last selected media.1 Press .2 Select ( ) the icon and press( ) to open the setup menus.3 Select ( ) [SYSTEM SETUP] andpress ( ).4 Select ( ) [MEDIA SEL. ] andpress ( ).5 Select ( ) [ DISC] or [ CARD]and press ( ) to save the settingand close the menu.When recording, the operating modesymbol will change to (DISC stills) or(CARD stills), depending on themedia selected. In playback mode, theoperating mode symbol will change to(DISC stills) or (CARD stills),respectively.PHOTOPHOTOPHOTO( 12)FUNC.( 31)FUNC.
