28Using the LCD MonitorThe LCD monitor can be used to confirm an image during shooting, to replayrecorded images or to adjust menu settings. Pressing the button switchesthe LCD monitor display mode.2 Shooting ModePressing the button cycles the LCD monitor to the next mode each timethe button is pressed.On (No Information) ➝ On (Information View) ➝ Off○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○• The on/off setting of the LCD monitor display mode is memorized when thecamera is turned off. When the camera is turned on again it assumes the lastmode. However, when the LCD monitor is turned on and the “Change the BatteryPack” message appears, the LCD monitor may not automatically turn on the nexttime the camera is started.• When the LCD monitor is set to On (No Information) or Off, shooting informationappears for approximately 6 seconds when you take any of the following actions.• The power is turned on.• The , or button is pressed.• The focus is set with the manual focus.• The aperture value and the shutter speed have been set with themulticontroller’s CDBA buttons.• The Shooting mode is changed.• Setting the mode dial to or turns on the LCD monitor regardless ofwhether it is set to on or off.○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○The camera shake warning icon will appear on the LCD monitor in low lightconditions while the camera is preparing to shoot. When this icon appears, set theflash to On or Auto, or fix the camera to a tripod to shoot.2 Replaying Mode• The LCD monitor turns on when you turn on the camera in Replaying mode.• Pressing the button cycles the information view mode each time thebutton is pressed.Single Replay (p. 105): Simple Display Detailed Display No DisplayIndex Replay (p. 107): Simple Display No Display
