Canon REALiS WUX10 Mark II D User Manual
Also see for REALIS WUX10 MARK II D: BrochureBrochureProduct guideUser manualBrochure & specs
                        | |
Contents
|
2CCHAPTER 2 • Routine OperationSetting the Protocol of a Projector2.5.7Projectors in the Projector list will display as "Disconnected" if network settings of projectorsare changed. In this case, adjust the protocol settings of the projector labelled "disconnected"in accordance with the changed network settings, with the following procedures.Select [Protocol settings] from the [Projector] menu.1 "Protocol settings" dialog will appear.Select a protocol from the [Protocol] pop-up menu, and adjust the settings.2Category DescriptionIP address Enter an IP address of the projector, in "XXX.XXX.XXX.XXX" form.Community name(SNMP V1/V2c/V3 only)E n t e r a c o m m u n i t y n a m e w i t h i n 1 5 o n e - b y t ealphanumerical characters and symbols.Port number(LV Series only)Enter a port number to be used, in one-byte numbers.Default value is set to "7142".Timeout Enter a number of seconds to time out, from 1 to 9.Password(SNMP V3 only)Enter a password within 8 to 15 one-byte alphanumericcharacters and symbols.NoteAn error message will appear and settings will not be registered if a value-of an entry is invalid or insufficient. Correct it as required.Entries will be cancelled if [X] (Close) or [Cancel] button is clicked before-clicking the [OK] button.Click [OK] when you have finished adjusting the settings.3 Projector's protocol settings will be changed. |
Related manuals for Canon REALIS WUX10 MARK II D
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine