Recording Audio84Switching the Input (MIC Terminal)You can switch the input of the MIC terminal depending on whether you are using an externalmicrophone or an external audio source, such as a digital audio player. This procedure is notnecessary for the optional WM-V1 Wireless Microphone.1 Open the [MIC Terminal Input] screen.[FUNC.] > [MENU] > p > [MIC Terminal Input]2 Touch [Þ External Audio] or [ß Microphone] and then touch [X].• If necessary, activate and adjust the audio mix balance (A 84).Low Cut Filter (MIC Terminal)When you are recording using a microphone connected to the MIC terminal, you can activate the lowcut filter to reduce the sound of blowing wind, a car’s engine and similar ambient sounds.1 Open the [MIC Low Cut] screen.[FUNC.] > [MENU] > p > [MIC Low Cut]2 Touch [i On] and then touch [X].Audio MixWhen recording, you can mix audio from the built-in microphone with external audio from the MICterminal and adjust the mix balance for original sound effects. The external audio input can be from theoptional WM-V1 Wireless Microphone, a commercially available external microphone or from anexternal audio player (analog Line In).1 Connect the external audio source to the MIC terminal.2 Open the [MIC Terminal Input] screen.[FUNC.] > [MENU] > p > [MIC Terminal Input]3 Touch [Þ External Audio] or [ß Microphone] and then touch [K].• This step is not necessary after connecting the optional WM-V1 Wireless Microphone.4 Activate the audio mix.[Audio Mix] > [i On]5 Adjust the audio mix balance as necessary.• Touch [INT] (more of the sound from the built-in microphone) or [EXT] (more of the sound from theexternal audio) or drag your finger along the audio mix bar to adjust the mix balance as desired.6 Touch [X] to set the audio mix and close the menu.Operating modes:Operating modes:Operating modes:
