98If transmitter errors are displayed on the camera LCD monitor, refer to the examples ofcorrective actions in this section to eliminate the cause of the error. When an error hasoccurred, the <LAN> lamp on the transmitter blinks and the error number is shown on the LCDpanel. The error details can also be checked in the menu, [WFT settings] [Errordescription].Click the error number in the following chart to jump to the corresponding page.When the error below is displayedWhen “ERROR 01” is displayed on the WFT-E7 LCD panel,firmly reconnect the camera and the WFT-E7 with theinterface cable.* This error is not displayed on the camera LCD monitor.* This error is also displayed when the WFT-E7 is connected to a camera not compatible withthe WFT-E7.If [Waiting to retry transfer…] is displayedIf image transfer via FTP fails after shooting, thescreen on the left is displayed. Also, an error numberis displayed on the transmitter’s LCD panel, and the<LAN> lamp blinks in red. Check the error number andeliminate the cause of the error.Once the cause of the error is eliminated, the imageswhose transfer previously failed will be transferredautomatically.Note that if you cancel image transfer or turn off the camera, auto retry is not performed. Followthe steps on page 40 to transfer the images.Handling Error Messages11 (p.99) 12 (p.99)21 (p.99) 22 (p.100) 23 (p.100) 24 (p.101) 25 (p.102)26 (p.102)41 (p.103) 42 (p.104) 43 (p.104) 44 (p.104) 45 (p.105)46 (p.105) 47 (p.106)51 (p.106) 52 (p.106) 53 (p.106) 54 (p.106)61 (p.107) 62 (p.107) 63 (p.108) 64 (p.108) 65 (p.108)66 (p.109) 67 (p.109) 68 (p.109) 69 (p.109)71 (p.110) 72 (p.110) 73 (p.110)81 (p.110)91 (p.110)COPY
