41PROJECTING AN IMAGE FROM THE COMPUTERPerforming the Auto SetupWith the auto setup function, the following set of adjustments is performed automaticallywhen projecting an image from a computer. You can start the projection only with this oper-ation if the input signal has been appropriately selected.1 Select an input signal.Select an appropriate input signal by following the steps in the "Selecting an Input Sig-nal" section at the page 43 if you change the input signal due to changing the connec-tion to the computer or so.Skip this step if you have not changed the input signal since the last projection.2 Press the [AUTO SET] button.The Auto setup window appears.Auto focusAdjusts the focusing automatically.Auto keystoneCorrects the keystone distortion (in the vertical direction) automatically.Auto inputSets the image input signal automatically.Auto screen color*Performs the screen color correction (white balance adjustment) automati-cally.*: This is not enabled at the factory.z Among 4 functions above, the function that has been enabled in the menu is performedduring the auto setup. "Auto focus", "Auto keystone", and "Auto input" are enabled in the fac-tory.z You can manually set or adjust each function. You can set or adjust a specific function inde-pendently if you press the [AUTO SET] button during the manual adjustment.z Select [Greenboard] from [Screen color] when using a greenboard (dark green) as a screen(P86).z The auto focusing and the screen color correction may not be performed properly depend-ing on the brightness of the room or the condition of the screen. Adjust the image manuallyif such is the case.
