109E PlaybackChanging the Remote Sensor ModeTwo remote sensor modes and an off setting are available to prevent interference from other Canonwireless controllers being used nearby.Turning the Remote Sensor OffOpen the menu and select [SYSTEM/ ]. Select [WL.REMOTE], set it to [OFF ] andclose the menu.“ ” appears.Changing the Remote Sensor Mode1. On the camcorder, open the menu and select [SYSTEM/ ]. Select [WL.REMOTE], setit to [ 2] and close the menu.The selected mode appears for a few seconds.2. On the wireless controller, press and hold the REMOTE SET button. Press the ZOOMT button for mode 2. Keep the button pressed for over 2 seconds.If you have set the camcorder to mode 1, press the ZOOM W button for mode 1. The wireless controller returns to mode 1 when you replace the batteries. Change the mode ifnecessary. Make sure that the camcorder and wireless controller are set to the same mode. Display thecamcorder’s mode by pressing any button on the wireless controller (except the REMOTE SETbutton) and set the wireless controller’s mode to the same mode. Change the batteries if thewireless controller still does not work.MENU( 31) SYSTEM/ WL.REMOTE•••• 1MENU( 31) SYSTEM/ WL.REMOTE•••• 1