Canon ZR70 MC A Service Manual

Contents

Canon ZR70 MC A Service Manual Manual pdf 171 page image

ZR70 MC A, ZR65 MC A, ZR60 ACHAPTER 4. DISASSEMBLING ADJUSTMENT4-362-3 IS Section AdjustmentNote)(1) Perform the IS adjustment after machine is re-assembled to a product status.(2) Prepare a tripod or stable work bench.(3) Each of the adjustment data (2-3-1 and 2) becomes valid when 2-3-3 data writing is made. After completion of each adjustment, besure to carry out 2-3-3 before turning power OFF.(4) The result data (*) of automatic adjustment is indicated in blinking because of the design of the MI-COM system.2-3-1 GYRO OFFSET AdjustmentSPEC. Automatic adjusutmentProcedure)(1) Wait at least 10 seconds while being careful not to apply vibration to the camera.(2) Referring to the table shown below, perform the automatic adjustment.Note)It will take approx. 25 seconds at maximum to complete adjustment (OK) after storing (pressing the pause button).2-3-2 GYRO GAIN AdjustmentSPEC. Data WritingProcedure)(1) Reset the data to be the original, referring to the table shown below.ST EP PROCEDURE Microcomputer operationGYRO OFFSET CS Function MD ADDR DT1 1) Make the setting shown at right. 2 08 ST 320D 002) Perform storing. RD *02 Adjustment is completed.(press the PAUSE button.) Completion with DT :02, NG with DT :03MONIT ORST EP PROCEDURE Microcomputer operationGYRO GAIN CS Function MD ADDR DT1 Gyro YAW gain adjustment1-1 1) Make the setting shown at right. 2 08 ST 3200 912) Perform storing. RD Adjustment is completed.(press the PAUSE button.)2 Gyro PIT CH gain adjustment2-1 1) Make the setting shown at right. 2 08 ST 3201 752) Perform storing. RD Adjustment is completed.(press the PAUSE button.)MONIT OR