Canon ZR70 MC A Service Manual

Contents

Canon ZR70 MC A Service Manual Manual pdf 76 page image

ZR70 MC A, ZR65 MC A, ZR60 ACHAPTER 1. GENERAL DESCRIPTION OF PRODUCT1-737-9 Using Analog Line Recording and DV Recording(1) Move the power switch to the VCR position and the Tape/Card switch to the TAPE. If a cassette has been inserted it will be stopped.The terminal (DV, S, AV) are set to output. In addition, the headphone terminal (if that setting is selected from the menu), whichalso serves as the AV jack, and the speaker are set to output (the headphone status takes priority).(2) Connect a cable from a recording source to the S-VIDEO terminal (video signal) and AV terminal (audio signal), or to the AVterminals (video and audio signals), or to the DV terminal. Power on the recording source.* If recording is paused while input is being received from terminals other than the DV terminal, the AV jack isautomatically set as the AV input terminal.If more than one of the above terminals is connected at the same time, the active terminal is selected automatically according to thefollowing order of priority.Order of priority : DV terminal > S terminal > AV terminalNote that when the playback screen is displayed (including Superb Playback), the playback screen takes priority.(3) Press [REC STANDBY] on the remote control.Recording is paused. If analog line input is being used, the S terminal and AV terminal are switched to input at this time.(4) To start recording, press [ / ] on the remote control.This starts recording of video, audio etc. through the terminal selected in step (2)(Press [ / ] to toggle between recording and pausing.)(5) Press [] to stop recording.Recording is stopped.* If DV input disappears during DV recording, then recording is stopped.* If a recording source is input to the DV terminal during analog line recording, recording is continued without change. Whenrecording is paused, the input is switched to DV input.* CGMS (Copy Generation Management System; copy protection) input signal• Only input signals (CGMS = 00) that are not copy-protected can be recorded.• If a copy-prohibited input signal (CGMS = 11) or single-copy-allowed input signal (CGMS = 10) is detected duringrecording or when recording is paused, then recording is paused.• Blue background is output to the LCD panel and CVF. The speaker and headphone output is muted.• Both audio and video CGMSD (Copy Generation Management System for Digital) signals are detected during DV input.The signal with the stronger copy protection setting is used.The Following Table Summarizes the Input and Output Statuses in Different Modes.* : No signal if there is no LINE input.DV input signal present No DV input signalLCD, CVF DV terminal S, AV terminals LCD, CVF DV terminal S, AV terminalsPlayback Playback screen OUT OUT Playback screen OUT OUT(including Superb Playback)No tape, STOP, FF, REW DV input screen IN OUT Blue background OUT OUTREC PAUSE, REC DV input screen IN OUT Line input screen* IN IN