89EEditing1. Open the menu and select VCR SET UP.2. Select AUDIO DUB.3. Select AUDIO IN or MIC. IN and close the menu.4. Locate the point where you want to start audio dubbing, then pressthe PAUSE button.• You can use the playback buttons on the body of the camera or the specialplayback functions on the wireless controller in the same way as in playbackmode.• The camera becomes set to playback pause mode.AUDIO DUB.••AUDIO INVCR SET UP( 35)REW PLAY FFSEARCHSELECTZERO SETMEMORYAUDIODUB.STOPA/VINSERTPAUSE SLOW+ /– /×2OFFPOWERVCRP.SCANMOVIEREMOTEDo not connect/disconnect any cables to/from the camera when dubbing audio orpreparing to dub audio.PreparationsDubbingTurn the camera’s POWER dial to VCR and load a recorded cassette.• Make sure the REC/SAVE tab on the cassette has been slid to REC (closedposition).• When you add sound using the built-in microphone make sure not to connectany cables to the MIC terminal (on the DU-300).• To use your TV to monitor video, connect the S-video terminal ( 30) or theA/V terminal (use only the video plug) to your TV. You can monitor the soundwith headphones ( 65).VCR
