Canon iR2030 Portable Manual

Also see for iR2018 Series: Service manual Brochure & specs Brochure & specs Easy operation guide Service manual

Contents

Chapter 5205.1.1.3.2 Detailed Discussions of Bit 70017-6056iR2022i / iR2025 / iR2030 / iR2018 / iR2022 / iR2018iUse it to enable/disable transmission of a 1080-Hz tonal signal before transmission of the CED signal.Select 'transmit' if errors occur frequently because of an echo when reception is from overseas.Memo:Any of the following error code may be indicated because of an echo at time of reception##0005, ##0101, ##0106, ##0107, ##0114, ##0200, ##0201, ##07905.1.1.4 SSSW-SW045.1.1.4.1 List of Functions0017-6057iR2022i / iR2025 / iR2030 / iR2018 / iR2022 / iR2018iT-5-35.1.1.4.2 Detailed Discussions of Bit 20017-6058iR2022i / iR2025 / iR2030 / iR2018 / iR2022 / iR2018iUse it to select the number of last flag sequences for a protocol signal (transmission speed at 300 bps). Select '2' if the other party fails to receive the protocol signalproperly.Memo:Any of the following error codes may be indicated at time of transmission##0100, ##0280, ##0281, ##0750, ##0753, ##0754, ##0755, ##0758, ##0759, ##0760, ##0763 ##0764, ##0765, ##0768, ##0769,##0770, ##0773, ##0775, ##0778,##0780, ##0783, ##0785, ##07885.1.1.4.3 Detailed Discussions of Bit 30017-6059iR2022i / iR2025 / iR2030 / iR2018 / iR2022 / iR2018iUse it to select an appropriate reception mode after transmission of the CFR signal.If errors occur frequently at time of reception because of the condition of the line, select 'high speed' for reception mode and, at the same time, selects 'do not receive'for 'ECM reception.'Memo:Any of the following error codes may be indicated at time of reception because of line condition##0107, ##0114, ##0201Be sure to change bit 4 before changing this bit; if errors still occur, change this bit.When 'high speed' is selected, only high-speed signals (images) will be received after transmission of the CFR signal.2 not used - -3 not used - -4 not used - -5 not used - -6 not used - -7 tonal signal before CED signal transmission transmit do not transmitBit Function 1 00 not used - -1 not used - -2 the number of final flag sequences of protocol signals 2 13 Reception mode after CFR signal transmission high speed high speed/low speed4 the length of the period of ignoring low speed signals afterCFR output1500 ms 700 ms5 CI signal frequency check at the time of PBI setting Check Not6 CNG signal for manual transmission Not transmitted Transmitted7 CED signal for manual reception Not transmitted TransmittedBit Function 1 0