Chapter 1313-5paper:COPIER>ADJUST>FEED-ADJ>ADJ-RE-LAn increase of '1' will decrease the left/rightimage margin on the front side by 0.1 mm.F-13-174) Record the new setting on the service label:- ADJ-REFE- ADJ-RE-L5) Press the Reset key twice to end service mode.13.1.4 Manual Feed Tray 0007-4910iR2270 / iR2870 / iR3570 / iR4570A. Adjusting the Left/Right Image Margin (1stside; mechanical)1) Put paper in the manual feed tray.2) Make a copy using the manual feeder as the sourceof paper, and check to be sure that the left/right imagemargin is 2.5 +/-1.5 mm.- If not as indicated, make the following adjustments:3) Remove the paper from the manual feed tray.4) Loosen the fixing screw [1] on the upper over of themanual feed d tray.F-13-185) So that the margin is as indicated, move the topcover of the manual feed tray back and forth.Moving the top cover of the manual feed tray towardthe rear of the machine will decrease the left/rightimage margin along the front side.6) Tighten fixing screw on the top cover of the manualfeed tray.7) Put paper in the manual feed tray.8) Make a copy using the manual feed tray as thesource of paper, and check to make sure that themargin is as indicated.13.1.5 Side Paper Deck 0007-4911iR2270 / iR2870 / iR3570 / iR45701) Check to make sure that the 4 adjusters [1] of thepedestal of the host machine are in contact with thefloor.F-13-19Paper left edgeIncrease theADJ-REF-L setting.(an increase of '1'will decrease themargin by 0.1 mm)Decrease theADJ-REF-L setting.(a decrease of '1'will increase themargin by 0.1 mm)108654202nd side of large-sizedouble-sided copy: 2.5 2.0mm[1][1]
