Chapter 1515-3515.3.2 Error Codes 0008-0315iR2270 / iR2870 / iR3570 / iR4570T-15-8The combination of characters used in thesearch condition fails to make up a correctsearch condition.There must be as many "s as there are "sThe symbol * is not included withinparentheses.Check to be sure that the combination ofcharacters is in keeping with the rule; then, tryonce again.If LDAP of the server and the character code isversion 2 (JIS), there is a character that is notpart of the ASCII code (0x20-0x7E).Remove any character that cannot be used;then, try once gain.The version setting of the server is wrong, and the search cannot be initiated. Check thesettings.In user mode, the LDAP server settings (serverLDAP version and character code) is set forversion 3; however, the LDAP server isoperating for version 2.In user mode, set the LDAP server settings sothat the LDAP server version and the charactercode are both version 2.Cause Remedy# 001There is a paper or original jam. Remove the jammed paper or original.# 003A communication lasting longer than a specificperiod of time (64 min) will cause an error state.1. Decrease the resolution for transmission.2. In the case of reception, ask the source todecrease the resolution or divide the original.# 005The target does not respond within 35 sec. Check to be sure that the target is ready tocommunicate; then, try once again.The target is a non-G3 model. Check the target.# 009There is no paper. Supply paper.The cassette is not fitted properly. Fit the cassette correctly.# 011Cause Remedy
