Cause Corrective ActionThere are sheets left on theEjection Guide.Printing will resume, starting from the page on which the error occurred.(See "Loading Rolls in the Printer.") →P.442There is a foreign object by theOutput Tray, obstructing the Cut-ter Unit.1. Lift the Top Cover and remove the foreign object.2. If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press theOK button.Printing will resume, starting from the page on which the error occurred.You are not using the printer un-der the recommended environ-mental conditions for the paper.Use the printer only where the recommended environmental conditions for the paper are met. Note thatvarious environmental conditions are recommended for various types of paper. For details on the recom-mended environmental conditions for paper, see Paper Reference Guide."(See Paper Reference Guide.)You are using paper that is notcompatible with automatic cut-ting.1. Specify Manual as the cutting method and use scissors or a cutting tool to cut the roll.(See "Specifying the Cutting Method for Rolls.") →P.454For information about paper that is compatible with automatic cutting, see the Paper Reference Guide.(See Paper Reference Guide.)2. Push the Release Lever back and remove the paper.In other cases, the Cutter Unitmay be damaged.Contact your Canon dealer for assistance.End of paper feed.End of paper feed.Cause Corrective ActionYou are pressing the ▲ button on the Control Panel and trying to rewind the roll to the edge. Release the ▲ button.Rel lever is in wrong position.Rel lever is in wrong position.Cause Corrective ActionThe Release Lever is pushed back. Pull the Release Lever forward.Turn off the printer and wait a while before restoring power.Borderless printng not possible.Borderless printng not possible.Cause Corrective ActionThe print job received specifies a typeor width of paper that is not compatiblewith borderless printing.Follow these steps to change the settings of the print job to enable borderless printing.1. Press ▲ or ▼ to select Stop Printing, and then press the OK button.2. Make sure the correct printer driver for the printer is selected and try printing again.For information on types of paper compatible with borderless printing, refer to the Paper Refer-ence Guide.(See Paper Reference Guide.)Select None when you have set Detect Mismatch on the control panel to Warning.However, note that this error may cause paper jams and affect the printing quality.Press ▲ or ▼ to select Print With Border, and then press the OK button to continue printing. Thedocument will be printed with a border.The loaded paper is a size not compati-ble with borderless printing.Press ▲ or ▼ to select Stop Printing, and then press the OK button.Replace the paper with paper compatible for borderless printing as follows.1. Press ▲ or ▼ to select Change Paper, and then press the OK button.(See "Removing the Roll from the Printer.") →P.447(See "Removing the Roll Holder from Rolls.") →P.4502. Replace the paper with paper compatible for borderless printing.(See "Attaching the Roll Holder to Rolls.") →P.439(See "Loading Rolls in the Printer.") →P.442iPF760 End of paper feed.User's GuideError Message Messages regarding paper641
