Canon imageRUNNER 2520 Series Service Manual

Also see for imageRUNNER 2520 Series: Service manual

44-6MEMO:Any of the following error codes may be indicated at time of reception because of linecondition##0107, ##0114, ##0201Be sure to change bit 4 before changing this bit; if errors still occur, change this bit.When 'high speed' is selected, only high-speed signals (images) will be received aftertransmission of the CFR signal.Detailed Discussions of Bit 4Use it to select the time length during which low-speed signals are ignored after transmissionof the CFR signal.If the condition of the line is not good and, therefore, the reception of image signals is difficult,select '1500 ms.'Detailed Discussions of Bit 5In the countries that need approval of CI signal frequency check, no checking on frequencyset at PBX when changing the frequency to PSTN setting and PBXsetting for frequency checks.Detailed Discussions of Bit 6Selects whether or not to transmit CNG signal during manual transmission.In manual transmitting to a fax with the FAX/TEL switching mode, if there are frequent errorsdue to failure to switch to fax mode, select "Transmitted" for the CNG signal.Detailed Discussions of Bit 7Selects whether or not to transmit CED signals during manual reception. If the other fax doesnot transmit even when you start manual reception, select "Transmitted" for the CED signal.SSSW-SW05List of FunctionsBit Function 1 00 not used - -1 Conversion from mm to inch (text mode) execute do not execute2 Conversion from mm to inch (text/photo mode) execute do not execute3 transmit bit 33 and thereafter for DIS signal prohibit do not prohibit4 Recording paper length availability declared inDIS signalA4 /B4 size Arbitrary size5 not used - -6 not used - -Bit Function 1 07 not used - -Detailed Discussions of Bit 1Use it to enable/disable millimeter/inch conversion in sub scanning direction for images readin text mode.Scanning direction in conversion follows the Bit 2 setting of SW14.Detailed Discussions of Bit 2Use it to enable/disable millimeter/inch conversion in sub scanning direction for images readin text/photo mode while bit 1 is set to '1'.Scanning direction in conversion follows the Bit 2 setting of SW14.Detailed Discussions of Bit 3Use it specify whether or not to transmit bit 33 and thereafter for the DIS signal.If ‘prohibit’ is selected, Super Fine reception from a non-Canon machine can no longer beused.CAUTION:If ‘prohibit’ is selected, Super Fine reception from a non-Canon machinecan no longer be used.Detailed Discussions of Bit 4Selects whether or not the recording paper length declared in the DIS signal is A4 size.When receiving documents made up of long pages, to have the document divided into twopages at the transmitting fax, select “A4 size”.MEMO:When “A4 size” is selected, this fax uses the DIS signal to tell the transmittingfax that it is equipped with A4 size recording paper.The transmitting fax that receives this DIS signal divides long pages into A4 size pagesbefore transmitting it to the receiving fax.Some fax models do not so divide long documents.T-4-6T-4-6All manuals and user guides at all-guides.com