Settings Menu 2-152Printer Settings Menu Offset X/Offset Y-2.00 to +2.00 inch (in increments of 0.01 inch); 0.0* inchThis setting sets the offset position in inches. The settings can be set between-2.00" (-50.0 mm) and +2.00" (+50.0 mm) in increments of 0.01" (0.5 mm).The print position is adjusted in the vertical or horizontal direction to the valuespecified in the setting value.You can increase or decrease the setting in increments of 0.01" (0.5 mm) to adjustthe print position, as described below.Offset X: Increasing the setting value moves the image in the rightward Xdirection on the paper. Decreasing the setting value moves the image in theleftward X direction on the paper.Offset Y: Increasing the setting value moves the image in the downward Ydirection on the paper. Decreasing the setting value moves the image in theupward Y direction on the paper.IMPORTANTPlease note that if the print position is adjusted to place print data outside the validprint area, the portion outside the valid print area is not printed.NOTE• If this setting is used in combination with the Margin setting, the values of the twosettings are added together.• Pressing [ ] increases the setting value by 0.01" (0.5 mm) each time the key ispressed. Pressing [ ] decreases the value by 0.01" (0.5 mm) each time. Holdingdown either [ ] or [ ] continuously speeds up the value alteration.DEFABCDEFX XY YAdjust usingX/Y-AdjustmentArea adjusted usingY-Adjustment[+]Area adjusted usingX-Adjustment[+]Front Back Front BackABCPart of theoriginal margin