Editing84ESetting the Audio MixAUDIOMONITORMIXBALANCEST-1 ST-2CAMERAOFFVCRPOWERWhen you play back a tape that was recorded in 12-bit mode, you can set theaudio output to play: stereo 1 (the original sound), stereo 2 (any new sound,dubbed to the tape after recording), or mix the balance between the two.• Audio from the 16-bit mode only contains stereo 1 sound and so you cannot/donot need to select the audio mix. The same is true for the 12-bit stereo 1 mode,unless new sound has been added post-recording.• You can choose the output using the wireless controller only.1. Turn the POWER switch to VCR.2. Choose the output.• Press AUDIO MONITOR on the wireless controller.• Starting with the last selected setting, four settings appear as you push thebutton:– STEREO1 for just stereo 1.– STEREO2 for just stereo 2.– MIX/FIXED for an equal mix of stereo 1 and 2.– MIX/VARI. (mix variable) for when you want to mix the balance betweenstereo 1 and 2.• To simply choose STEREO1, STEREO2 or MIX/FIXED, make sure yourchoice appears on the display.• If you choose MIX/VARI., you can go on to mix the balance.• Use the ST-1/ST-2 keys to mix the balance. A bar showing the mix appearson the screen for four seconds.• When you have chosen the output, STEREO1, STEREO2, MIX/FIXED orMIX/VARI. is shown in the top left of the display for a few seconds. If you turnthe power off the output is set to STEREO1.4_ZR10_E(73-85) 3/9/00 7:59 PM Page 84 (1,1)