Maintenance-74-5After Use CareCutting System• Never place any part of body under cutting blade shield when cutting blade isrotating.• Do not allow bystanders to come near machine when cutting blade is rotating.• Always stay on machine when performing this opeartion• Never attempt to clean cutting system with cutting blade shield open. Stones orrocks can be thrown and cause damage to surrounding properties or persons.• Turn cutting rotary clutch to [ON] only when cleaning. Keep it in [OFF] positionall the other times.1. Park machine.2. Set cutting height to about 50mm.5323M-0511-010ECap3. Remove cap and connect hose. Run waterthrough hose.4. Start engine.5. Turn throttle lever to [ (fast)] to raiseengine speed.6. Move cutting rotary clutch lever to [ON] torotate cutting blade to clean.7. When cleaning is done, move cutting rotaryclutch lever to [OFF] to stop cutting blade.• Do not set cutting height too low It may hitground.NOTE
