Carrier 33AW-CS1 User Manual

Also see for Comfort series: Installation instructions Limited warranty Owner's guide Owner's manual Installation instructions

Contents

Carrier 33AW-CS1 User Manual Manual pdf 7 page image

7Programming the ControlUse this blank grid to write down your required hometemperatures.You’ll assign time periods to those temperatures later.Touch ‘N’ Go Option Heat CoolHomeAwaySleepTo change the factory settingsFactory defaults for User ConfigurationPress and hold the comfort button1.( ) to be changed for about fiveseconds. The set temperature along with the symbolheat ( ) or cool ( ) will flash.Press the up or down button on the right side of2.the display until you reach the desired temperaturesetting for the current mode of operation. At thismoment the triangle icon ( ) above the pressedcomfort button ( ) will start flashing.To change the mode, press the mode (M) button3.repeatedly until you see the required mode symbolflashing on the screen.Press the up or down button on the right side of4.the display until you reach the desired temperaturesetting.Pressing one of the other two Touch 'N' Go button,5.item 2 to 4 can be repeated.Press OK button to confirm changes and exit from the6.Comfort change mode.Procedure for Changing the User Parameter settings toDefault values is given below.Press simultaneously home (1. ) and away ( )buttons at a time for 10 seconds to enter into the userconfiguration mode. When this setting is first selected,999 will be displayed in the time display area and aninitial value of 10 will be displayed in the temperaturedisplay area.Press and hold the down button. When the counter2.reaches zero, “Fd” will be displayed in the temperaturedisplay area. This represents factory defaults are inprogress. Upon successful completion of restoringdefaults to EEPROM, the NUI will then force a reset.English