Carrier 40GVC Owner's Manual

Also see for 38GVC: Product data Installation instructions

Contents

Carrier 40GVC Owner's Manual Manual pdf 6 page image

6REMOTE CONTROLEQUIPMENT DAMAGE HAZARDFailure to follow this caution may result in equipment damage.Handle the control with care and avoid getting the control wet.CAUTION!NOTE: To switch between _C and _F, push the “MODE” and“--” button simultaneously while the unit is off.IMPORTANT: The remote control can operate the unit from adistance of up to 25 ft. (7.6 m) as long as there are no obstructions.This is one way communication only (from remote control to fancoil).The remote control can perform the following basic functions:S Turn the system ON and OFFS Select operating modeS Adjust room air temperature set point and fan speedS Adjust airflow directionRefer to the Remote Control Function section for detaileddescription of all the capabilities of the remote control.Battery InstallationTwo AAA 1.5 v alkaline batteries (included) are required foroperation of the remote control.To install or replace batteries :1. Slide the back cover off the control to open the battery com-partment.2. Remove old batteries if you are replacing the batteries.3. Insert batteries. Follow the polarity markings inside thebattery compartment.4. Replace battery compartment cover.A08299NOTE:1. When replacing batteries, do not use old batteries or a differenttype battery. This may cause the remote control to malfunction.2. If the remote is not going to be used for several weeks, removethe batteries. Otherwise battery leakage may damage the remotecontrol.3. The average battery life under normal use is about 6 months.4. Replace the batteries when there is no audible beep from theindoor unit or if the Transmission Indicator fails to light.Remote Control Operation -- Quick StartNOTE: When transmitting a command from the remote control tothe unit, be sure to point the control toward the LED display on thefront panel of the unit. The unit will confirm receipt of a commandby sounding an audible beep.1. Turn the unit on by pushing the ON/OFF button.2. Select the desired mode by pushing the mode button.(Only for heating and cooling units)A08301NOTE: Cool only units have no heat mode.3. Select the temperature set point by pointing the control to-ward the unit and pressing the “+” or “--” temperature setpoint buttons until the desired temperature appears onscreen.4. Select the desired fan speed by pressing the FAN SPEEDbutton to select desired fan speed.NOTE: If unit is operating in Dry mode (X--FAN), low fan speedwill be displayed and the fan speed cannot be changed.5. Set the airflow direction. When the unit is turned on, thelouvers default to the cooling or heating position. The usercan adjust the default louver position by pushing the“SWING” buttons. For details on operating the SWINGlouvers, refer to the Remote Control Functions section.Emergency OperationIf the remote control is lost, damaged, or the batteries areexhausted, the ON/OFF button on the unit can be used to run theunit.Press the ON/OFF button once briefly when the system is off.To stop emergency operation, push the ON/OFF button once.ON/OFF ButtonA12547Combination of “MODE” and “--” Buttons:Switches between Fahrenheit and Centigrade. At unit OFF, press“MODE’” and “--” buttons simultaneously to switch between _Cand _F.