6REMOTE CONTROLTIMER ONCLOCKFANDRY COILTURBO SLEEP LIGHTTEMP TIMER OFFAUTOFAN OPERºFºCHOURON/OFF:** Display shown is for 40GXM units. For 40GXC(Q) units, LED display is in upper right corner.A09647EQUIPMENT DAMAGE HAZARDFailure to follow this caution may result in equipment damage.Handle the control with care and avoid getting the control wet.CAUTION!NOTE: The remote control is set from factory to displaytemperatures in _F. If _C is desired, turn the remote OFF andthen press “MODE“ and “--” buttons on the remotesimultaneously.IMPORTANT: The remote control can operate the unit from adistance of up to 25 ft. (7.6 m) as long as there are no obstructions.This is one way communication only (from remote control to fancoil).The remote control can perform the following basic functions:S Turn the system ON and OFFS Select operating modeS Adjust room air temperature set point and fan speedS Adjust airflow directionRefer to the Remote Control Function section for detaileddescription of all the capabilities of the remote control.BATTERY INSTALLATIONTwo AAA 1.5 v alkaline batteries (included) are required foroperation of the remote control.To install or replace batteries :1. Slide the back cover off the control to open the battery com-partment.2. Remove old batteries if you are replacing the batteries.3. Insert batteries. Follow the polarity markings inside thebattery compartment.4. Replace battery compartment cover.A08299NOTE: 1. When replacing batteries, do not use old batteries ormix different types of batteries. This may cause theremote control to malfunction.2. If the remote is not going to be used for several weeks,remove the batteries. Otherwise battery leakage maydamage the remote control.3. The average battery life under normal use is about 6months.4. Replace the batteries when there is no audible beepfrom the indoor unit or if the Transmission Indicatorfails to light.SET THE CLOCKBefore you start operating the air conditioner, set the clock on theremote control as outlined below. The clock panel on the remotecontroller will display the time regardless of whether the airconditioner is in use or not.Initial Setting of the Clock:After batteries are inserted in the remote control, the clock panelwill display ”12:00”.1. Push the CLOCK button once; will flash2. Push the “+” or “--” button. Each time you press the button,the time moves forward or backward by one minute de-pending on which button you press.If you push the “+” or “--” buttons continuously, the timeadjusts in increments of 10 minutes.3. When the right time is achieved, press the CLOCK buttononce to set the time. The will stop flashing.4. To readjust the Clock, Press the CLOCK button on the re-mote. The will flash. Repeat steps 1 through 3.NOTE: Note: The time of the CLOCK must be set before theAUTO--TIMER function will operate.UNIT OPERATION HAZARDFailure to follow this caution may result in equipmentdamage or improper operation.Static electricity or other factors (voltage fluctuations) cancause the remote control clock to reset. If your remotecontrol is reset (the time of ”12:00” flashing), set the clockbefore starting the unit.CAUTION!