Carrier 40RC003603 Owner's Manual

Contents

7Entering to ZoneMultiple systems of the indoor units are set as a zone. Start/Stop control and every kind setting are available in eachzone. At shipment from the factory, one unit as one zone is set in 64 zones each.(NOTE 1) If a unit is set to an incorrect zone, set the unit to the correct zone another time.(The zone which has been finally set/entered is valid.)(NOTE 2) A unit cannot be set to multiple zones.(NOTE 3) While zone entering is set up, the unit which has been already entered is indicated with unit No. and “ ” in theoperation monitor indication part when zone No. is indicated.Set up and entering[Set up example]Set Unit No. “1”, “2”, “3”, “4”, “5” to Zone No.1.1 Push “ZONE SET/ENTER” button while “MONI-TOR” is indicated.Indication changes to [ZONE SET].2 Pushing “ZONE” button indicates Zone No.”1”.“SET”, “ZONE”, “UNIT” indications and the UnitNo. entered in the corresponding zone go on.“1” is indicated at shipment from the factory.Unit No.1 is set to Zone No.1.3 Pushing “UNIT” button indicates Zone No.”2”.“02” in Unit No. indication part and No.“2” inOperation monitor indication part flash.4 When pushing “SELECT” button, the flashingUnit No. in the operation monitor indication partgoes on.Repeat steps3 and4, and select Unit No. 3,4, and 5.5 When “ZONE SET/ENTER” button is pushed,the contents are entered.(Unit No. and “ ” in the Operation monitorindication part change to lighting .)1SET ZONE UNIT2 3 4 501 02 03 04 05 to 62 63 6464 63 62 61 60 to 03 02 01FILTER RESET1SET ZONEONUNIT2LOUVERFANTEMP.MODEMONITOR/SET ALL/ZONE ZONE UNIT ON CENTER/LOCKED CHECKZONE SET/ENTER SELECT OFF TIMER ONFILTER RESET49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 6433 34 35 36 37 38 39 40 41 42 43 44 45 46 47 4817 18 19 20 21 22 23 24 25 26 27 28 29 30 31 321MONITOR ONONUNIT2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 TEMP.˚CLOUVERFANTEMP.MODEMONITOR/SET ALL/ZONE ZONE UNIT ON CENTER/LOCKED CHECKZONE SET/ENTER SELECT OFF TIMER ON15 4 2 3MODECOOLFANHIGHENDPush “MONITOR/SET” button again. The Zoneset up completes and indication returns to“MONITOR”.Indication returns automatically to “MONITOR”after 15 seconds even if this step is not ex-ecuted.When setting another zone continuously,repeat steps2,3,4, and5.Every pushing “ ” buttons of ZONE and UNIT, indication No.moves up by 1, and moves up successively by keepingpushed. Every pushing “ ” buttons of ZONE and UNIT,indication No. moves down by 1, and moves down succes-sively by keeping pushed.[ZONE SET]