Carrier AQUAZONE 50RHC006-060 Series Product Data

Contents

33AL — Alarm Relay ContactsBM — Blower MotorBMC — Blower Motor CapacitorCAP — CapacitorCB — Circuit BreakerCC — Compressor ContactorCO — Sensor, Condensate OverflowFP1 — Sensor, Water Coil Freeze ProtectionFP2 — Sensor, Air Coil Freeze ProtectionHP — High-Pressure SwitchHWTS — High (Leaving) Water Temp SwitchJW1 — Jumper, AlarmLOC — Loss of Charge Pressure SwitchTYPICAL AQUAZONE™ DELUXE D CONTROL WIRINGLEGENDMV — Motorized ValveP1 — Field Wiring Terminal BlockPM — Performance MonitorRVS — Reversing Valve SolenoidTRANS — TransformerTXV — Thermostatic Expansion ValveField Line Voltage WiringField Low Voltage WiringPrinted Circuit TraceRelay/Contactor CoilCondensate PanSolenoid CoilThermistorGroundWire NutNOTES:1. Compressor and blower motor thermally protected internally.2. All wiring to the unit must comply with NEC and local codes.3. Transformer is wired to 208 v (RED) lead for 208/3/60. For 230/3/60switch RED and ORG leads at L1 and insulate RED lead.4. FP1 thermistor provides freeze protection for water. When using anti-freeze solutions, cut JW3 jumper.5. Typical Aquazone thermostat wiring shown. Refer to thermostat instal-lation instructions for wiring to the unit. Thermostat wiring must beClass 1 and voltage rating equal to or greater than unit supply voltage.6. 24-v alarm signal shown. For dry alarm contact, cut AL2 dry jumperand dry contact will be available between AL1 and AL2.7. Transformer secondary ground via control board standoffsand screws to control box. (Ground available from top twostandoffs as shown.)8. Blower motor is factory wired for medium and high speeds.For any other combination of speeds, attach the lowerspeed wire to fan speed relay N.O. wire.9. Aquastat is supplied with unit and must be wired in serieswith hot leg to the pump. Aquastat is rated for voltages up to277 v.