Carrier Air V Owner's Manual

Also see for Air V: Installation instructions Owner's guide Owner's guide Owner's guide Owner's manual

Contents

Carrier Air V Owner's Manual Manual pdf 10 page image

OWNER’ S GUIDE -Secure the ceiling assembly frame to the roof topair conditioner with the mounting bolts (See ,Figure 4). You must start (thread) the mountingbolts* by hand to avoid cross-threading. DO NOTSTART THE MOUNTING BOLTS WITH AN AIR GUN.The mounting bolts should be tightened evenly.Do not over-tighten each bolt. The bolt tighteningprocess is complete when the basepan gaskethas been evenly compressed to 60%.Pull the fabric duct collar through the ceilingassembly frame opening and pull the four cornersto extend below the duct opening(See , Figure 4).9Make sure that you have properly matched the roof top air conditioner and interior ceiling assembly. The followingstep by step instructions must be performed in the following sequence to insure proper installation.SERIAL NUMBEROF UPPER UNITSERIAL NUMBEROF CEILING UNITSTEP 2 - INSTALLING THE CEILING ASSEMBLYFigure 4Carefully take the ceiling assembly out of thecarton. (The controls are factory installed in theceiling assembly.)Remove the ceiling grille from the ceiling assemblyframe.Before the ceiling assembly can be mounted tothe roof top air conditioner, the fabric duct collarmust be fastened to the basepan of the airconditioner with 4 screws (See , Figure 4 andFigure 4-1).Before lifting (mounting) the ceiling assembly, checkthe gasket on the underside of the roof top airconditioner. The gasket must be positioned properlyover the roof opening.Before lifting the ceiling assembly, pull the fabricduct collar so it hangs out of the way and does notget caught under the ceiling assembly frame.123456If your ceiling depth is thinner than 2”, youshould use shorter bolts(5” long) at the frontside.(2ea)*CAUTION (for low profile)7