154.4 - Compressor usage and electrical data tableCompressorreferenceI Nom I Max lRA Circ. 30RW/30RWA020 025 030 040 045 060 070 080 090 110 120 135 150 160 185 210 245 275 300DQ 12 CA 025 EE 9.9 13.7 86 A A1BDQ 12 CA 001 EE 12.6 17.6 130 A A1 A1BDQ 12 CA 002 EE 14.6 20.4 130 A A2 A2 A1 5.759 mmBDQ 12 CA 031 EE 17.9 25.9 135 A A1 A2 A1 + A2 A1 + A2B A1 + A2DQ 12 CA 032 EE 21.1 30.2 155 A A1 A1 + A2 A1 A1 + A2 A1B A1 + A2 B1DQ 12 CA 027 EE 27 39 215 A A2 A1 + A2 A1 A2 A1 + A2 A1B B2 B1 + B2 B1DQ 12 CA 028 EE 34 48 270 A A2 A1 + A2 A2 A1 + A2B B2 B1 + B2legendI Nom Nominal current draw (A) at standard Eurovent conditions (see definition of conditions under nominal unit current draw)I Max Maximum operating current (A) at 400 VLRA Locked rotor current (A)ED1050-5-10-15-20-10 -5 0 5 10 15454035302520155 - APPlICATION DATA5.1 - Operating limits 30RW/RWA30RW/30RWA Entering water temp., °C leaving water temp., °CEvaporator Minimum Maximum Minimum MaximumAt start-up 7.5 30 5 (note 1) 15At shut-down - 50 - 50During operation 5 (note 1) 15 50 5030RW Condenser Entering watertemperature, °Cleaving watertemperature, °CWith hydronic module andvariable-speed pumpAt start-up/during operation (min.) -15 -During operation (max.) 47 (note 3) 52Without hydronic moduleAt start-up/during operation (min.) 20 (note 2) 25During operation (max.) 47 (note 3) 5230RW Drycooler Entering air temperature, °CWith hydronic module and variable-speed pumpAt start-up/during operation (min.) -20During operation (max.) (note 4)Without hydronic moduleAt start-up/during operation (min.) (note 5)During operation (max.) (note 4)30RWA Air-cooled condenser Entering air temperature, °CAt start-up/during operation Minimum MaximumWith variable-speed fan -10 (note 6)With fixed-speed fan 0 (note 6)Notes1 30RW/30RWA units can operate from 4°C to 0°C without modification.In all cases the units must be configured for low leaving-water temperature,and use of antifreeze is required.2 30RW units without hydronic module operating below 20°C enteringcondenser water temperature require the use of a three-way valve controlledfrom the 0-10 V analogue output of the Pro-Dialog control.3 For a flow rate corresponding to a condenser Δt of 5 K.4 The maximum entering air temperature is based on the drycooler selection.5 The minimum entering air temperature range is between 15 and 20°C (withoutthe use of three-way valves)Operation at -15°C ambient temperature is possible with the use of a three-way valve to maintain the required minimum condensing temperature (seenote 2).6 The maximum entering air temperature is based on the remote condenserselection.IMPORTANT: Maximum ambient temperatures. Forstorage and transport of 30RW units the minimum andmaximum temperatures must not go beyond -20°C and50°C. It is recommended that these temperatures are usedfor transport by container.5.2 - Operating range 30RWNotes 30RW1 Evaporator and condenser ∆T = 5 K2 For 30RW units without hydronic module with an entering condenser watertemperature below 20°C a three-way valve is required to allow operation, whilemaintaining the correct condensing temperature.3 For 30RW units equipped with a hydronic module the minimum entering watertemperature is -15°C.4 Maximum leaving condenser water temperature is 52°C (at full load)A Standard unit with without antifreeze solutionB Standard unit operation with the anti-freeze solution required and controlconfiguration for a leaving water temperature down to 0°C.C Standard unit operation with the anti-freeze solution required and controlconfiguration for a leaving water temperature down to -10°C.D Operation at high air temperature is based on the drycooler selected.E Operation at low air temperature is possible down to -20°C with a drycooler.Condenser leaving water temperature, °CEvaporator leaving water temperature, °CEvaporator leaving water temperature, °CDrycooler entering air temperature, °CC B A52454035302520-10 -5 0 5 10 1550