Carrier NUI 33AW-CS2 User And Installation Manual

Contents

Carrier NUI 33AW-CS2 User And Installation Manual Manual pdf 7 page image

7Programming the ControlTo change the factory settingsPress and hold the comfort button1.( or or ) to be changed for about fiveseconds. The set temperature along with the symbolheat ( ) or cool ( ) or domestic water ( ) willflash.Select the desired zone by pressing the zone (2. )button repeatedly.If zone 1 or 2 is selected, press the mode (M) button3.to switch between heat ( ) and cool ( ).Press the up or down button on the right side of4.the display until you reach the desired temperaturesetting for the current mode of operation. At thismoment the triangle icon ( ) above the pressedcomfort button ( ) will start flashing.Press the up or down button on the right side of5.the display until you reach the desired temperaturesetting.Pressing one of the other two Touch 'N' Go button,6.item 4 to 5 can be repeated.If needed select a different zone and repeat steps 37.to 6.Press OK button to confirm changes and exit from the8.Comfort change mode.Changing the temperature time periodsAfter you have set temperature settings for home, away andsleep, you can program the time of day you want to use forthose temperature settings.Time ranges are called periods; zone 1 and zone 2 havemaximum 6 periods; zone 3 has maximum 4 periods.Periods are identified on the display as P1, P2, P3, P4, P5and P6.The thermostat has preset periods (see below), but you canchange these to fit your lifestyle.To select the number of periods, refer to the (user)parameters table in the unit documentation.Period Period Start TimeZone 1 / Zone 2 Zone 3P1 6:00 6:00P2 8:00 8:00P3 12:00 18:00P4 14:00 24:00P5 18:00 Not availableP6 22:00 Not availableNote: zone 1 and zone 2 have the same time periods.English