– 22 –4-way Air Discharge Cassette Type Installation ManualEN8 APPLICABLE CONTROLSREQUIREMENT• When you use this air conditioner for the first time,it takes approx. 5 minutes until the remote controlbecomes available after power-on. This is normal.installation>It takes approx. 5 minutes until the remote controlbecomes available.later) time>It takes approx. 1 minute until the remote controlbecomes available.• Normal settings were made as factory default.Change the indoor unit settings as required.• Use the wired remote control to change thesettings. Changing applicable controlsettingBasic procedure for changing settingsChange the settings while the air conditioner is notworking.(Be sure to stop the air conditioner before makingsettings.)Procedure 1Push button and temp. setup buttonsimultaneously for at least 4 seconds.After a while, the display flashes as shown in the figure.Confirm that the CODE No. is [01].• If the CODE No. is not [01], push button to erasethe display content, and repeat the procedure fromthe beginning.(No operation of the remote control is accepted for awhile after button is pushed.)Procedure 2Each time you push button, indoor unitnumbers in the control group change cyclically. Selectthe indoor unit you want to change settings for.The fan of the selected unit runs and the louvers startswinging. You can confirm the indoor unit for which youwant to change settings.* The settings cannot be changed using thewireless remote control, sub remote control,or remote-controlless system (for centralremote control only). Therefore, install thewired remote control to change the settings.Poweron“SETTING”flashes“SETTING”goes outRemotecontrol isavailableApprox. 5 minutesPoweron“SETTING”flashes“SETTING”goes outRemotecontrol isavailableApprox. 1 minutes1613254(* Display content varies withthe indoor unit model.)22-EN