Carrier VVT Zone Installation And Startup Manual

Contents

Carrier VVT Zone Installation And Startup Manual Manual pdf 33 page image

VVT Zone Controller 29To start up the VVT Zone Controller, you need one of the following user interfaces. These items let you accessthe controller information, read sensor values, and test the controller.This interface... Provides a...i-Vu Open Permanent interfacesoftwareField Assistant software -runs on a laptop connected to controller's Local Access portTemporary interface1Virtual BACview software -runs on a laptop connected to controller's Local Access portTemporary interface1, 2BACview6 Handheld keypad/display unit -connects to controller's Local Access portTemporary interface1, 2BACview6 keypad/display unitconnected to controller's Rnet portPermanent interface21 Requires a USB Link (USB-L).2 See the BACview Installation and User Guide for instructions on connecting and using the above items.Configuring the VVT Zone Controller's propertiesTo start up the VVT Zone Controller, you need to configure the properties described in the following sections.These properties affect the unit operation and/or control. Review and understand the meaning and purposeof each property before changing it.• Unit Configuration properties 30(page )• Setpoint Configuration properties 30(page )• Service Configuration properties 33(page )• Linkage properties 34(page )See Appendix A (page 51) for a complete list of the controller's points/properties.NOTE Engineering units shown in this document in the defaults and ranges are strictly for reference. Youmust enter an integer only.Start-up